Parts for uds?
Posted: Tue Oct 01, 2019 4:29 pm
Looking for pipe to do my inlet and outlet on my uds. Cant find any black pipe in my area,Gympie Qld. Or do people use galvanised? Not sure I like that idea. Also for mesh for a basket.
Aussie BBQ Forum
Aussie BBQ Forum - The biggest BBQ site in Australia
https://www.aussiebbq.info/forum/
Parts for uds?
Page 1 of 1
Re: Parts for uds?
Posted: Wed Oct 02, 2019 4:32 pm
I used gas pipe and fittings from Bunnings plumbing dept.
Re: Parts for uds?
Posted: Wed Oct 02, 2019 10:43 pm
galvanised stuff?
Re: Parts for uds?
Posted: Fri Oct 04, 2019 3:51 pm
Re: Parts for uds?
Posted: Sun Oct 06, 2019 4:11 pm
ok thanks 
Re: Parts for uds?
Posted: Sat Oct 19, 2019 5:08 pm
Drum is built wondering do i need an ash catcher on chimney? I have a large fire hazzard running through yard. How many embers do these things spit out?
- Resized_20191017_135411.jpeg (213.64 KiB) Viewed 8934 times
Re: Parts for uds?
Posted: Mon Oct 21, 2019 10:37 am
Looking good!
Minimal to no sparks.
They would have to make it all the way up to the top of the barrel, find the bottom of the chimney and then up and out. Also they are not running grilling temps, just ticking over on low and slow.
Maybe a little hat would be sufficient?
Minimal to no sparks.
They would have to make it all the way up to the top of the barrel, find the bottom of the chimney and then up and out. Also they are not running grilling temps, just ticking over on low and slow.
Maybe a little hat would be sufficient?
Re: Parts for uds?
Posted: Mon Nov 11, 2019 5:27 pm
I ended up putting stainless mesh over chimney then a hat to stop rain..
I have used it fair bit and your right no sparks and very low heat I can hold end of chimney. Works awesome and cooks delicious food. I have been using heat beads brand lump charcoal. I dont use extra wood. I reakon it has enough flavour. Nice thin blue smoke
I have used it fair bit and your right no sparks and very low heat I can hold end of chimney. Works awesome and cooks delicious food. I have been using heat beads brand lump charcoal. I dont use extra wood. I reakon it has enough flavour. Nice thin blue smoke
Re: Parts for uds?
Posted: Mon Nov 18, 2019 7:21 pm
Fantasticblucmal wrote: ↑Mon Nov 11, 2019 5:27 pm I ended up putting stainless mesh over chimney then a hat to stop rain..
I have used it fair bit and your right no sparks and very low heat I can hold end of chimney. Works awesome and cooks delicious food. I have been using heat beads brand lump charcoal. I dont use extra wood. I reakon it has enough flavour. Nice thin blue smoke
