First post here.
Recently got into the science that is BBQ and have invested in a ProQ Excel 20 Elite. I am just starting to get my head around keeping a stable temp but I seem to be going through a lot of fuel to cook a small amount of meat.
So far I have only been using the top stacker i.e having the smoker completely assembled (two tiers) but only using the top grill.
First question is if I am only using one grill should I remove the top stacker and just use the grill directly over the water pan? Would this in theory save my fuel purely because there is less of a surface area to heat?
Also If I want to cook on both stackers for are there any tips in terms of which type of meat goes where, what meats shouldn't be cooked together and fuel arrangements? I gave it a half hearted crack when I first bought the smoker but failed miserably as the meat I put on seemed to sap all the heat and I could get it back up to cook temp before the fuel ran out. I think this is what scared me off.
I use Kingsford original briquettes and have only tried the minion method so far. Was considering giving the snake a crack to get a longer low and slow cook temp.
Any advice on any of these points would be welcomed as I feel I have invested in a great piece of kit but am not using it to its full potential.
All about smokers
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests